Zebra Z Series User Manual

Printer Setup
Select a Data Communication Interface
30
79695L-002 Rev. A Z Series
®
/RZ™ Series User Guide 6/6/08
USB No additional configuration is necessary.
Caution • Be careful not to plug the USB cable into the wired Ethernet
print server connector on the printer because doing so will damage the
connector.
Internal wired
Ethernet print
server
Refer to the ZebraNet 10/100 Print Server User and Reference Guide for
configuration instructions. A copy of this manual is available at
http://www.zebra.com/manuals or on the user CD that came with your
printer.
Note • To use this connection, you may need to remove a factory-
installed plug that is designed to keep someone from accidentally
plugging a USB connector into this port.
Wireless
Ethernet print
server
Refer to the ZebraNet Wireless User Guide for configuration instructions.
A copy of this manual is available at http://www.zebra.com/manuals or on
the user CD that came with your printer.
Table 6 • Connecting the Printer to a Computer or Network (Continued)
Interface Connection and Configuration

Zebra Z Series Specifications

General

Print Method	Thermal Transfer or Direct Thermal
Max Print Width	4.09 in./104 mm (depending on model)
Max Print Length	39 in./991 mm (with 203 dpi)
Connectivity	USB, Serial (depending on model)
Supported Media Types	Wristbands
Media Width	1.0 inch (25.4 mm)
Operating Temperature	40°F to 104°F (5°C to 40°C)
Storage Temperature	-40° F/-40° C to 140° F/60° C
Resolution	203 dpi or 300 dpi (depending on model)