Zebra Z Series User Manual

115
Troubleshooting
LCD Error Messages
6/6/08 Z Series
®
/RZ™ Series User Guide 79695L-002 Rev. A
LCD Error Messages
The LCD displays messages when there is an error. See Table 16 for LCD errors, the possible
causes, and the recommended solutions.
Table 16 • LCD Error Messages
LCD Display/
Printer Condition
Possible Cause Recommended Solution
The ERROR light flashes.
The printhead was replaced with
one that is not a genuine Zebra™
printhead.
Install a genuine Zebra™ printhead.
The printer stops; the
ERROR light flashes.
In thermal transfer mode, ribbon is
not loaded or incorrectly loaded.
Load ribbon correctly. See Load
Ribbon on page 55.
In thermal transfer mode, the
ribbon sensor is not detecting
ribbon that is loaded incorrectly.
1. Load ribbon correctly. See Load
Ribbon on page 55.
2. Calibrate the sensors. See
Calibrate Media and Ribbon
Sensor Sensitivity on page 83.
In thermal transfer mode, media is
blocking the ribbon sensor.
1. Load media correctly. See Load
Media on page 41.
2. Calibrate the sensors. See
Calibrate Media and Ribbon
Sensor Sensitivity on page 83.
In thermal transfer mode, the
printer did not detect the ribbon
even though it is loaded correctly.
1. Print a sensor profile. See Print
Sensor Profile on page 82. The
ribbon out threshold (marked by
the word
RIBBON) is likely too
high, above the black area that
indicates where the ribbon is
detected.
2. Calibrate the sensors or load
printer defaults. See Calibrate
Media and Ribbon Sensor
Sensitivity on page 83 or LOAD
DEFAULTS on page 65.
ERROR CONDITION
INVALID HEAD
ERROR CONDITION
RIBBON OUT

Zebra Z Series Specifications

General

Brand	Zebra
Model	Z Series
Category	Printer
Language	English