To Next Page

To Previous Page

Venezia Use, Care, and Installation Guide

VENEZIA

WALL

CORE

Installation Instructions

Mounting the Hood

At least two installers are required due to the

weight and size of the hood.

CAUTION

1. Measure from range top to hood bottom and

mark line A. (24” minimum from range top).

2. Plum and mark center line.

3. Mark mounting height line B. (10-1/4” from line

4. Mark mounting spread from C/L on line B. From

center line to left mount mark (3-9/16”). From

center line to right mount mark (4-3/4”)

Wood blocking may need to be added behind

the drywall if no studs are present. Wall anchors

may also be used but check local codes for

compliance. Failure to use suitable wall anchors

and screws to hold the weight of the hood could

result in personal injury or damage to cooking

surface or counter.

WARNING

FIG. B

Duct Cover Bracket

C/L

10-1/4"

C/L

24" min

3-9/16"

4-3/4"

5. Fasten (2) M4 x 1-1/4” screws into studs on line B. Do not fasten screws all the way.

6. Hang hood onto screws and hand tighten. (FIG. B1) Use the last M4 x 1-1/4” screw to further

secure the hood to the wall from inside the hood.

7. Center and attach duct cover bracket to wall below ceiling or sot using (2) #6 x 1” screws.

8. Remove tape securing electronics mounting bracket to hood. Reposition electronics mounting

bracket to hood and secure by two pre-installed screws as shown in (FIG. A1).

9. Install electrical.

Zephyr Venezia User Manual

Questions and Answers: