EN
17
EN
1) Close the main water supply valve.
2) Please empty the water tank completely using the continuous extraction
method (See Chapter ‘How to Use’).
3) Please remove the top cover, and then un-hook the fixed clip holding the
top cover of the water tank. Now open the tank cover.
4) Separate the Hygienic filter from the water tank cover and shaking and
cleaning it in the drained water. Install again after cleaning.
➊
➋
CLEANING
2) Open the top cover of the product and open the front cover. (Loosening
two screws with a screwdriver, lift off the front cover).
Tip - Don’t push the extraction lever with excessive force.
You may damage the product as a result.
3) Separate the fitting connected to the specific filter and then replace the
filter. (Separate the fitting with an appropriate tool).
Tip - Change the filter and connect the fitting and the hose carefully, check
that there is no leakage and drain the first purified water.
4) Close the front cover by fitting into the grooves. Tighten the two screws
on the front cover with a screwdriver. Close the top cover.
Tip - If several filters are being replaced, perform cleaning of three minutes
in between filter replacement.
➊
➊
➋
FILTER NAME CLEANSING TIME COMMENT
Neo-sense filter 30 seconds
Inno-sense filter 3 minutes Please use Neo-sense filtered water for cleansing
Membrane filter 3 minutes Please use Neo-sense filtered water for cleansing
To Next Page
Loading...
General