Relay Cards
Chilli Pro can have dimmer channels replaced with relays, by fitting a relay card. Relay cards are 4 channel boards,
which can be used to replace blocks of 4 dimming channels with relays. These relays can then be controlled by DMX,
to switch the connected load.
Relay cards are available as a primary and secondary board. The primary card includes a PSU, and so a single
primary card can be added to give 4 relay channels. Additional secondary cards can then be added and powered off
the primary, to give more relays.
Chilli Pro 12 can have a single primary card, with a pair of secondary cards powered from the primary, to provide all 12
channels as relays.
Chilli Pro 24 can have a pair of primary cards, and a pair of secondary cards powered from each primary, to provide all
24 channels as relays.
When using relays channels, the channels must be configured to use a "Switch" dimmer law in the dimmer
settings. Click here for more information.
Click here for fitting instructions.
Relay Card Fitting Instructions
Introduction
Chilli dimmers can have blocks of 4 dimmer channels replaced with relays. Chilli Pro MK3 support six cards (2 primary
and up to 4 secondary). The secondary cards must be placed directly above or below a primary card. Chilli MK1 &
MK2 support three cards (1 primary, and up to 2 secondary).
These instructions are for the following upgrade kits:
0095-000108-00 - Primary Relay Card & PSU Kit
0095-000109-00 - Secondary Relay Card Kit
To confirm your version of Chilli dimmer, see the link below...
https://zero88.com/manuals/chillipro/introduction-105/chilli-pro-versions
Chilli Channel Outputs
Zero 88 - Chilli Pro - Page 49 of 60 Printed: 23/03/2021 09:13:40 ES
To Next Page
Loading...
Need help?
General