Over the years, where possible, core parts were kept the same, and the MK1 and MK2 dimmer parts were completely
interchangeable. However changes to the keypad/power PCB kits and output PCB on the MK3 are unique to this
version.
Identifying Chilli Pro 24 versions
The simplest way to identify the dimmer type is by the configuration of the breakers as shown below:
MK1 & MK2
Visually there is little difference between the MK1 and MK2 versions. Both have a single metal door on the right-hand
side that covers the breakers. It is only the configuration of the breakers that tells them apart. The MK1 has a single
stack of 24 breakers, whereas the MK2 has the breakers split into groups of four.
MK3
The MK3 version is visually different to the MK1 & MK2. This has a door that covers the whole of the dimmer front
panel and a lock on the left-hand side of the door. Breakers are then configured into two stacks of 12. The bypass
variant will also have two stacks of 12 button switches below the breakers.
Zero 88 - Chilli Pro - Page 5 of 60 Printed: 23/03/2021 09:13:40 ES
To Next Page
Loading...
Need help?
General