Quickstart Tutorial
Introduction
This chapter enables you to get the
Frog-Box unit up and running quickly,
and to load and playback a show.
This tutorial assumes that a suitable
show has been programmed on one of
the Frog series of lighting desks and
saved onto a floppy disk .
It also assumes that a lighting rig has
been set up with dimmers, luminaires
and moving light fixtures (if applicable),
which are controlled by a standard
DMX signal.
Turning on the Frog-Box
Connect the DMX cable(s) to the
socket(s) on the rear panel of the unit.
Connect the power supply to the unit
and switch on at the mains.
Frog Box 73-749-00 Issue 4 2 - 1
Figure 2 - 1: The Frog-Box Replay Unit
For news, views and
latest software visit
our dedicated Frog
web site at
www.frogsupport.com
To Next Page
Loading...
Need help?
General