15 zhiyun-tech.com
How to Start Up
2.After the batteries are installed properly, long press the power button for 3 sec. to power on.
Please use batteries provided or approved by ZHIYUN only, otherwise it may cause accidents. When using
the stabilizer , please hold the camera with one hand to prevent severe shaking of the camera in case a
malfunction occurs to the stabilizer (in very rare cases).
1. Rotate to loosen the end cover, then install two 26500
Li-ion batteries. Make sure to tighten the end cover
properly after battery installation, or the stabilizer
cannot be turned on.
Batteries shall be installed with the positive pole
heading the arrow direction as shown above.
Start Up
To Next Page
Loading...
Need help?
General
