7
Installation and Balance Adjustment
① Before mounting the camera, make sure it is prepared ahead of time.
Remove the lens cap and make sure the camera's battery and memory card
are already in place.
② Each axis of the stabilizer is equipped with a lock switch. You can use these
lock switches to lock the axes for convenient installation and storage. The
storage state is the default state. Please unlock three axes, expand the
stabilizer as shown in the image and lock the axes again for convenient
camera installation.
Lock state for storage Lock state for installation
1.Mount the camera on the camera
backing base. Tighten the bottom
screw and ensure a firm installation.
You may decide whether or not
to use the camera backing base
depending on your camera-lens
combo. You will need the camera
backing base in the following
situations:
① When mounting external follow
focus motor.
② When using lenses with larger
diameters, such as the Canon
RF24-70mm F2.8 L IS USM
lens.
Mount the Camera
To Next Page
Loading...
Need help?
General
