Assembly
Figure 1. Carefully remove your Zip’r Pathfinder knee scooter from
its packaging. When unpacking your scooter, the front axle will be
turned left.
Figure 2. Pull down on the guide pin ring and turn the front axle so
that the guide pin ring is between the guide stops. Release the guide
pin ring and your front axle is set in the proper position.
Figure 3. Secure the steering column by pushing the clamp lever to
the left which will allow the safety pin to lock into place. Raise the
clamp lever upward into the “U” shaped slot and tighten by turning
clockwise. Push the clamp lever down firmly to secure the steering
column.
Figure 4. Secure the center frame hinge by connecting the front and
rear frame sections by closing the center frame hinge.
To Next Page
Loading...
Need help?
General
