18
Installation instructions & user manual
T210023 v1.02 NOV 2018 - ZIP AP430S-AP4100S
Technical support
Tel: 0345 6 005 005 email: service@zipindustries .co.uk www.zipwater.co.uk
Maintenance
• Clean the exterior of the Aquapoint using a soft cloth and mild detergent intended for
cleaning smooth varnished surfaces.
• Do not use detergents that contain alcohol or abrasives.
• Regular servicing will ensure faultless functioning and a long life of the Aquapoint.
• Tank corrosion warranty applies only if all the prescribed regular inspections of the
protective anode wear have been made.
• The period between regular inspections should not be longer than stated in the warranty
certicate.
• Upon inspection the service provider will inspect the amount of wear on the anti-corrosion
anode and, if necessary, clean the limescale that accumulates depending on the quality,
quantity and temperature of the water inside the heater.
• The service provider will also recommend the date for the next inspection depending on
the condition of the heater.
Service & maintenance
See warnings and cautions page 5
Operation
The Anti-Legionella Function
If the water in the heater does not reach 65°C for 14 consecutive days, the anti-legionella
function heats the water to 70°C and maintains this temperature for 120 minutes.
Emptying the heater
• If you are planning to disconnect the Aquapoint from power supply, please drain out all the
water to prevent freezing.
• Water from the heater that is installed vertically on the wall can be drained through the
heater's inlet pipe.
• For this purpose it is advisable to install a T- piece with an outlet valve between the inlet
pipe and safety valve.
Please do not attempt to x any defects of the Aquapoint by
yourself. Call the nearest authorised service provider.
To Next Page
Loading...
Need help?
General
