Page 6 Zip Tudor - Installation & Operating Instructions - 81333 - February 2010 V2
Operating Procedures
Control Panel
Water Temperature
Zip Tudor water heaters are fully automatic, and may be left switched ON under the control of the variable
thermostat.
Nominal operating temperature can be varied from about 30°C to about 80°C.
Temperature should not be set to less than 60°C without due regard to regulations governing the storage
temperature of hot water.
Economy Setting
The economy setting “E” will maintain stored water temperature
at approximately 60°C. At the “E” setting, the temperature control
locates into a set position and a slight resistance will be felt when
rotating the temperature control beyond that setting. This measure is
to help ensure that higher temperatures are only selected deliberately.
Frost Protection
If the heater is located where ambient air temperature could fall below
5°C when the heater is not in use, the “anti freeze” setting on the
temperature control will maintain stored water temperature over 5°C
to prevent freezing and damage to the water heater.
The same protection does not extend to connecting pipework or fittings.
Safety Cutout
Should the heater over-heat, a manually resettable safety cutout will automatically turn the heating element OFF. The
cutout must be reset by a Zip Service Provider or a licensed electrician. Users should never reset the cutout without
qualified assistance.
Cleaning
Never use strong, corrosive or abrasive cleaning materials. Wipe clean the outer surfaces with a sponge or soft cloth
using a mild soap and water. Domestic dish washing liquid detergent is most suitable.
PART NO DESCRIPTION
90401 element neck ring kit Tudor
90407 fascia kit Tudor undersink
90408 fascia kit Tudor oversink
90836 element kit
90420 pilot light kit Tudor
90421 thermostat kit Tudor
90423 overload kit Tudor
Spare Parts
ANTI-
FREEZE
ECONOMY
HIGH
OFF
LOW
To Next Page
Loading...
Need help?
General
