1GE Dual Mode ONU User Manual
Chapter 3 Configuration
After finishing the basic connection configuration, you can use its basic function. In order
to satisfy individuation service requirements, this charter provides the user parameter
modification and individuation configuration description.
This model of ONU is designed as SFU(single family unit, bridge mode), there is no bridge
mode WAN in ONU. When it works on bridge mode, VLAN of LAN port should be
configured by OLT. When it works on router mode, you may configure through its web
management.
3.1 Login
The device is configured by the web interface. The following steps will enable you to login:
1. Conform “2.2 Quick Installation” to install;
2. The device default IP is 192.168.1.1;
3. Open your web browser, type the device IP in address bar;
4. Entry of the user name and password will be prompted. Enter the default login user name
and password.
By default, there are two user levels for management. Administration level user name is
"admin", password is "stdONUi0i". Normal level user name is "user", password is
"user".
Figure 3-1: Login
For security, you will be asked to modify password after you logged in by default
password. The new password must meet the requirements that display on the webpage. After
submitted, it requires you to login by new password.
To Next Page
Loading...
Need help?
General
