WARNING!
No condensation is allowed. There are connectors that are connected to drive
main circuit potential.
Mechanical installation
1. Install a standard 35 × 7.5/15 mm DIN rail to the cabinet into which the unit is to be
installed.
2. Fasten the two latches to the back of the measurement unit with four screws.
3. Click the measurement unit to the rail as shown below.
4. Make sure that the installation rail is grounded properly, either via the assembly plate,
or with a separate grounding wire. The unit is grounded through the rail.
16 Installation
To Next Page
Loading...
Need help?
General
