Overview
12
The FENA-01 Ethernet Adapter module
The FENA-01 Ethernet Adapter module is an optional device for
ABB drives which enables the connection of the drive to an
Ethernet network. Through the FENA-01 Ethernet Adapter module
it is possible to:
• give control commands to the drive
(Start, Stop, Run enable, etc.)
• feed a motor speed or torque reference to the drive
• give a process actual value or a process reference to the PID
controller of the drive
• read status information and actual values from the drive
• change drive parameter values
• reset a drive fault.
Protocols used to access these functionalities over Ethernet (eg,
Modbus/TCP) and configuration of the FENA-01 Ethernet Adapter
module to use them are described in the respective Protocol
Manual.
The adapter module is mounted into an available fieldbus adapter
slot on the drive. See the drive documentation for module
placement options.
To Next Page
Loading...
Need help?
General
