Manual for Induction Motors and Generators
Introduction - 3
3BFP 000 050 R0101 REV E
1.4.2 Information not included in documentation
This User’s Manual does not include any information about any starting, protection or speed
control equipment. This information is provided in the user’s manuals for respective equipment.
1.4.3 Units used in this User’s Manual
The measurement units used in this User’s Manual are based on the SI (metric) system and the
US system.
1.5 Identification of the machine
1.5.1 Serial number of the machine
Each machine is identified with a 7-digit serial number. It is stamped on the rating plate of the
machine as well as on the machine frame.
The serial number must be provided in any future correspondence regarding a machine, as it is
the only unique information used for identifying the machine in question.
1.5.2 Rating plate
A stainless steel rating plate is attached permanently to the machine frame, and it must not be
removed. For the location of the rating plate, see Appendix Typical position of plates.
The rating plate indicates manufacturing, identification, electrical and mechanical information,
see Figure 1-1 Rating plate for direct on line machines manufactured according to IEC (Ex-
machine according to ATEX Directive).
Figure 1-1 Rating plate for direct on line machines manufactured according to IEC (Ex-
machine according to ATEX Directive)
To Next Page
Loading...
Need help?
General
