1. Introduction
NOTE!
These instructions must be followed to ensure safe
and proper installation, operation and maintenance
of the machine. They should be brought to the
attention of anyone who installs, operates or
maintains the machine or associated equipment.
The machine is intended for installation and use by
qualified personnel, familiar with health and safety
requirements and national legislation. Ignoring these
instructions may invalidate all applicable warranties.
1.1 Declaration of Conformity
Declarations of Conformity with respect to the Low voltage
Directive 73/23/EEC amended by Directive 93/68 EEC are
issued separately with individual machines.
The Declaration of Conformity also satisfies the
requirements of a Declaration of Incorporation with
respect to the Machinery Directive 98/37/EEC,
Art 4.2 Annex II, sub B
1.2 Validity
The instructions are valid for the following ABB electrical
machine types, in both motor and generator operation.
series MT*, MXMA,
series M2A*/M3A*, M2B*/M3B*, M4B*, M2C*/M3C*,
M2F*/M3F*, M2L*/M3L*, M2M*/M3M*, M2Q*,
M2R*/M3R*, M2V*/M3V*
in frame sizes 56 - 450.
There is a separate manual for e.g. Ex motors ‘Low voltage
motors for hazardous areas: Installation, operation and
maintenance Manual’ (Low Voltage Motors/Manual for Ex-
motors).
Additional information is required for some machine types
due to special application and/or design considerations.
Additional information is available for the following motors:
– roller table motors
– water cooled motors
– open drip proof motors
– smoke venting motors
– brake motors
– motors for high ambient temperatures
To Next Page
Loading...
Need help?
General
