Electrical connection
28 RHDE250 ... 4000 (Contrac) 42/68-167-EN
Pos: 13.4 /Überschri ften/1.1/1-spa ltig/G - L/Kabelschirm @ 10\ mod_1181823716656_31 01.doc @ 106187
5.1 Cable shield
Pos: 13.5 /Überschri ften/1.1.1/1-spal tig/Signalteil @ 10\ mod_1182501083765_31 01.doc @ 108573
5.1.1 Signal part
Pos: 13.6 /Elektri scher Anschluss/Aktor ik/Antriebe/Al lgemein/Kabelschi rm Anschluss @ 10\mod_11818 23021906_3101.doc @ 106144
3
3
4
2
2
1
1
M00307
Fig. 14: Fitting the shield
1. Remove approx. 2 cm of cable sheathing (3) from the end of the cable.
2. Separate the shield and peel it back to its inner sheathing (4).
3. Push the cable through the cable gland and fasten with clamp (1).
4. Make sure that the shielding is touching the clamp and the electronic unit housing (2).
Pos: 13.7 /Überschri ften/1.1.1/1-spal tig/Motor @ 10\mod_1182 501159359_3101.doc @ 108596
5.1.2 Motor
Pos: 13.8 /Elektri scher Anschluss/Aktor ik/Antriebe/Al lgemein/Kabelschi rm Motor @ 10\mod_1182501238 328_3101.doc @ 108619
The cable shield must be connected to the motor in a proper manner.
Pos: 13.9 /====== = Seitenumbruch ======= = @ 0\mod_1126532365768_3101.doc @ 3830
To Next Page
Loading...
Need help?
General
