5Introduction/Environmental protection program
I Introduction
—
This publication contains the information needed
to install medium voltage VSC vacuum contactors
and put them into service.
For correct use of the product, please read it
carefully.
This VSC retrofit solution is designed for
installation in the 800 mm width ABB UniGear ZS1
or similar designed panel (check of compatibility
of VSC 800 mm width in third–part panels shall
be done).
However, this apparatus allows further
technical-construction modifications (at the
customer’s request) to adapt to special
installation requirements.
Consequently, the information given below may
sometimes not contain instructions concerning
special configurations.
Apart from this manual, it is therefore always
necessary to consult the latest technical
documentation (electric circuit and wiring
diagrams, assembly and installation drawings,
any protection coordination studies, etc.),
especially regarding any variants requested in
relation to the standardized configurations.
Only use original spare parts for maintenance
operations.
For further information, please also see the
technical catalogue of VSC vacuum contactors
and the spare parts.
II Environmental protection program
—
These VSC contactors are manufactured in
accordance with the ISO 14000 Standards
(Guidelines for environmental management).
The production processes are carried out in
compliance with the Standards for environmental
protection in terms of reduction in energy
consumption as well as in raw materials and
production of waste materials.
All this is thanks to the environmental management
system of the medium voltage apparatus
manufacturing facility.
To Next Page
Loading...
Need help?
General
