67
Flagging Test Results
If you wish, you can “ag” your test result with an asterisk to mark a special result. You might want to
ag an event such as an after-meal (post prandial), exercise, or alternate site test result. When you review
your results in memory, this “ag” can help you remember what was different about the result.
Here is how to ag a result:
1. Perform a test.
2. With the test result on the display, and the test strip STILL IN THE
METER, press and release
S
S
once. The appears below the test
result.
3. Hold the meter so the test strip points downward. Slide and release
to turn off the meter and release the test strip.
4. Discard the used test strip.
Flag
NOTE
If you wish to remove again, press and release
S
S
twice.
man_07699336001_01_EN.indb 67 28.09.2015 13:26:47