Acer P1265 User Manual

35
English
Problems with the Projector
# Condition Solution
1 The projector stops responding
to all controls
If possible, turn off the projector, then
unplug the power cord and wait at least 30
seconds before reconnecting power.
2 Lamp burns out or makes a
popping sound
When the lamp reaches the end of its useful
life, it will burn out and may make a loud
popping sound. If this happens, the projector
will not turn on until the lamp module has
been replaced. To replace the lamp, follow
the procedures in the "Replacing the Lamp"
section.
http://www.pureglare.com.au

Acer P1265 Specifications

General

Number of colors	16.78 million colors
Projection distance	1 - 11.9 m
Vertical scan range	56 - 85 Hz
Horizontal scan range	31.5 - 100 kHz
Projection technology	DLP
Contrast ratio (typical)	2000:1
Screen size compatibility	0.58 - 7.62 \
Projector native resolution	XGA (1024x768)
Keystone correction, vertical	±40 °
Aspect ratio	4:3, 16:9
RS-232 ports	1
Dimensions (WxDxH)	299 x 229 x 93 mm
Throw ratio	1.95 - 2.15:1
Lamp type	P-VIP
Lamp power	180 W
Light source type	Lamp
Service life of light source	3000 h
Serial interface type	RS-232
USB 2.0 ports quantity	USB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them.
Noise level	28 dB
Market positioning	Presentation

Weight and Dimensions

Weight	3000 g