19
Installation
To install the monitor to your host system, please follow the steps as given below:
Steps
1 Connect Video Cable
a. Make sure both the monitor and computer are powered-OFF.
b. Connect the VGA video cable to the computer.
c. Connect the digital cable (only for dual-input models).
(1) Make sure both the monitor and computer are switched off.
(2) Connect one end of the 24-pin DVI cable to the back of the monitor and the other end to the computer's port.
2 Connect power cord
Connect the power cord to the monitor, then to a properly grounded AC outlet.
3 Turn on the monitor and computer
Turn on the monitor first, then the computer. This sequence is very important.
4 If the monitor still does not function properly, please refer to the troubleshooting section to diagnose the problem.
This Manual: http://www.manuallib.com/file/733325
To Next Page
Loading...
Need help?
General
