Active 2.3 User Manual

12
6. Operating Instructions
6.1 Working with Foam Blaster
Working with a detergent ensures quick soaking of
the dirt, and allows the high-pressure water
to penetrate and remove the dirt more effectively.
Always spray detergent on a dry surface, do not
pre-soak the area. Wetting the surface first dilutes
the detergent and reduces its cleaning ability.
CAUTION
Damage may occur to painted surfaces if
chemicals are allowed to dry on them. Wash
and rinse a small section at a time.
CAUTION
Failure to clean foam blaster properly will
cause the detergent injection system to
become clogged and inoperable.
Engage the safety lock on the spray gun.
1. Detach spray head by turning detergent
bottle 1/4 turn counter-clockwise. ( Rotate
spray head from vertical position to
horizontal position)
2. Fill the bottle with the detergent.
3. Reattach the spray head on to the bottle by
turning 1/4 clockwise.
Detergent
ON
Detergent
OFF
1. Attach the foam blaster onto
the QC wand.
2. Apply the detergent to dry work surface
from bottom to top.
3. Allow detergent to remain on the surface
for a short time before rinsing. Do not allow
detergent to dry on the surface.
4. When you finish working with detergent, fill
with clean water in bottle and spray water
for one minute in ON position to rinse the
Foam Blaster and remove any soap residues
that may clog it.
Set detergent ON(
) or OFF ( )by adjusting
the knob.
1
2
3
Operating Instructions
1 2

Active 2.3 Specifications

General

Brand	Active
Model	2.3
Category	Pressure Washer
Language	English