7
5. Assembly Instructions
5.1 Surface Preparation
Before beginning any cleaning task, it is important
to inspect the area for objects that could create
a hazard. Remove any objects from the work area
that could be tripped over, such as toys or outdoor
furniture. Ensure that all doors and windows are
closed tightly.
5.2 Water Supply (Cold Water Only)
Only draw water through the unit. The device must
be used with cold water supply only. The water
hose must be at least 1/2” (13 mm) in diameter.
The water flow rate must not fall below 4.8 GPM (18
LPM). The flow rate can be determined by running
water for one minute into an empty container. The
water supply temperature must not exceed 40 °C
(104 °F).
5.3 Safety Advice
5.4 Assembly
CAUTION
• Never use the pressure washer to draw in
water contaminated with solvents (e.g. paint
thinners, gasoline, oil, etc.).
• Dirt in the water inlet will damage the unit.
To avoid this risk, we recommend checking
the water filter (located inside the water
inlet. To clean it out, refer to the Cleaning and
Maintenance section).
• Always prevent debris from being drawn into
the unit by using a clean water source and an
additional accessory water filter, if required.
• To prolong the life of the unit, let it rest for 5
minutes aer every 30 minutes of use.
• Check to make sure you have all the parts.
Attach high-pressure hose to the gun and the
pump outlet (Hand tighten only).
Connect to the garden hose to the inlet adaptor
(Hand tigghten only).
Attach garden hose to water supply and turn
water on.
1
2
3
Assembly Instructions
To Next Page
Loading...
Need help?
General
