Agilent Technologies 8960 Series Programming Guide

15
S:\Hp8960\E1960A GSM Mobile Test Application\A.04 Release\Proguide\Chapters\prog_prog_guide_intro.fm
Programming the Agilent Technologies 8960 Series 10 for GSM Mobile Testing in Active Cell Operating Mode
Introduction
Figure 1. Typical Flow of Tasks Performed by Control Program
Step 5:
Set mobile station
operating conditions.
Step 4:
Establish active link
with mobile station.
No
Stop
No
Step 1:
Set test set’s operating
mode to active cell.
Step 2:
Configure base station
emulator (BSE).
Start
Step 7:
Perform
intra-cell handover.
Step 8:
Disconnect mobile
station from BSE.
Step 6c:
Obtain set of
measurement results.
Step 6b:
Determine if a
measurement
is done.
Step 3:
Configure measurement
execution parameters.
Step 6: Make measurements.
Step 6a:
Start set of concurrent
measurements.
Assign
mobile station
to new TCH?
All measurements done.
Yes
Yes

Agilent Technologies 8960 Series Specifications

General

Brand	Agilent Technologies
Model	8960 Series
Category	Test Equipment
Language	English