53
S:\Hp8960\E1960A GSM Mobile Test Application\A.04 Release\Proguide\Chapters\prog_prog_guide_step7.fm
Step 7: Perform an Intra-Cell Handover
Step 7: Perform an Intra-Cell Handover
Background
A handover is defined as assigning the mobile station to a new traffic channel. The test set is capable of
performing two types of handovers:
• Intra-cell handover: assigning the mobile station to a new traffic channel within the currently active
broadcast band.
• Dual-band handover: assigning the mobile station to a traffic channel in a traffic band which is different
from the currently active traffic band.
Performing an Intra-Cell Handover
An intra-cell handover is accomplished using the CALL:TCHannel command in conjunction with the :SEQ
synchronization command. The recommended process for performing an intra-cell handover is shown in the
following figure.
Step 7: Figure 1. Process for Performing an Intra-Cell Handover
Yes
No
Call connected?
Proceed with control
program.
Invoke error
handler.
Start
Change traffic
channel with :SEQ
To Next Page
Loading...
Need help?
General
