63
S:\Hp8960\E1960A GSM Mobile Test Application\A.04 Release\Proguide\Chapters\prog_prog_guide_comprehensive_prog_example.fm
Comprehensive Program Example
Comprehensive Program Example
This section presents two example programs for making measurements using the test set. The first program
follows the task flow presented at the beginning of the programming note (see “Figure 1. Typical Flow of Tasks
Performed by Control Program” on page 15) and which is discussed throughout the programming guide. The
second program, “Example Program Without Comments” on page 69, is basically the same as the first but
comments have been removed and the coding reflects the use of compound commands and complex commands
to achieve coding efficiency.
To Next Page
Loading...
Need help?
General
