41
N1010A FlexDCA and 86100A/B/C/D
Firmware Release Notes
86100A-Only Firmware Release Notes
A.03.01 Release Notes, February 15, 2002 (Differences from Release
A.02.20)
New Feature List
• Ability to acquire multiple channels at once in Eye Mode
• Ability to make measurement and mask analysis on multiple eyes at the same time
• Measurement results tab has a new look: clear meas button replaced by ?gx?h on
meas results tab and tab up/down button replaced by ?g?Þ?h on meas results tab
• Parametric mask creation
• Ohms/Division setting added for TDR mode
• Ability to annotate and delete individual measurements
• Add support for the following new modules: 86111U, 86111A, 86115B, 86113A,
86102A, 86103B, 86116A, 86107A, 83494A Options 103 and 107
Defects Fixed:
• When filter is turned on, autoscale switches filter when completed for no reason
• Trigger setting changes after autoscale
• System crash when non- TDR module is autoscaled in TDR mode
• Stop Menu item behaves as Stop/Single
• Source parameter is not being accepted with 'MEASure' subsystem commands
•Sending DISP:PERS INF in eye mode sets it to CGR
• Screen capture when in color grade saves files in grayscale
• Saving .jpg on full diskette results in 0 record length file
• Remote uploaded waveform memories are not stored on disk
• Remote command returns mainframe calibrated when it is not; added :CAL:REC
CHAn<N> command
• Quickmeasure attempts to measure waveform memories in eye mode
• Querying waveform values without waveform displayed hung the GUI
• Probe calibration hangs up box after remote command. We no longer initiate
optical cal if chan is electrical.
• Need more digits in read- out of X Markers at low time/div setting
• MTEST:START fails after running MTEST:LOAD on bad mask name, but displays
no warning
• MTEST:SAVE .msk saves as '.msk.pcm ? Measurement Results Tab drops in height
when changing modes
• Measurement limits do not work when restored from saved setups
• Mask test align failure does not cause an error in the queue
• Mask margins not working with CG- GS waveforms
•Markers could be moved outside of the window
• Incorrect max string length reported with remote SYST:DSP command
• Inconsistent behavior when saving a file to a full floppy
• Horizontal Scale/Division setting didn't do anything
• Can't remove unused measurement from measurement results tab
• Binblock download of versus function does not work
• Autoscale resets transducer conversion factors
To Next Page
Loading...
Need help?
General
