18
EDITING TIME DIVISION
The Time Division feature works in conjunction with Note Repeat. When Note Repeat is enabled and a pad
is held down, the MPD26 will output notes at a rate equivalent to the Time Division setting. To change to a
new Time Division setting, press and hold [TIME DIVISION] and select a new rate by pressing one of Pads 8-
16 (1/4, 1/4T, 1/8, etc.). To select the amount of Swing, press and hold [TIME DIVISION] and press one of
Pads 9-16 (54%, 56%, etc.). The adjustments you make to either parameter will be shown in the LCD.
Please refer to the following illustrations to better understand how the Time Division feature works with Note
Repeat:
With an 1/8 note Time Division setting, the sequence will
look like this.
With an 1/8T note Time Division setting, the sequence will
look like this.
With a 1/16 note Time Division setting, the sequence will
look like this.
With a 1/16T note Time Division setting, the sequence will
look like this.
With a 1/32 note Time Division setting, the sequence will
look like this.
With a 1/32T note Time Division setting, the sequence will
look like this.
1. To edit Time Division settings, press the [EDIT] button to enter Edit
Mode.
2. Now select Time Division for editing by pressing [TIME DIVISION].
3. You will see Page 1 displayed on the screen (shown on the left).
4. Press [ENTER] to edit the Time Division settings.
DEFAULT TIME DIVISION
Each Preset can have a default Time Division setting which is set every
time the Preset is loaded.
1. While in Default Time Division field, use [VALUE] dial to select the
default Time Division (1/4, 1/4T, 1/8, etc.)
2. Press [>] to select the next field.
PRESS ENTER TO EDIT
DEFAULT DIVISION FIELD
To Next Page
Loading...
Need help?
General
