en
Troubleshooting
32 469378_d
TROUBLESHOOTING
CAUTION!
Cutting blade and motor shaft may not be aligned if damaged!
Fault Solution
Motor does not start Filling with petrol
Set speed lever to "Start" position
Switch on the choke
Press the motor switch lever to the upper bar
Check the spark plug, replace, if necessary
Clean the air filter
Turn the mower blade free
Charge the starter battery
Start on mowed surface
Reduced motor performance ▪Correct cutting height
Sharpen / replace mower blade
Clean discharge chute / housing
Clean the air filter
Reduce working speed
Unclean cutting Sharpen / replace mower blade
Correct cutting height
Grass catcher does not fill
up completely
Correct cutting height
Allow lawn to dry
Sharpen / replace mower blade
Clean the grass catcher grid
Clean discharge chute / housing
Wheel drive does not func-
tion
Adjust the Bowden cable
V-belt defective
Contact the customer service workshop
Remove dirt in the wheel drive, V-belt, and transmission
Lubricate freewheels (drive pinion on drive shaft) with spray oil
Do not rotate wheels with
gearbox switched on
Retighten wheel bolts
Wheel hub defective
V-belt defective
Contact the customer service workshop
Unit vibrates strongly in an
unusual way
Check mower blade
ADVICE
If faults are not listed in this table or you are unable rectify them yourself, please contact our
customer service department.
To Next Page
Loading...
Need help?
General
