Operation
Cutting height adjustment
Adjust the cutting height according to the needs of your lawn.
The cutting height depends on the kind of lawn and its actual
height. When mowing high grass, start with the maximum
cutting height and make a second cut with a lower cutting
height.
WARNING!
Always check the mounting plates before assembling
the wheels. Never attach the wheel on a damaged or
loose mounting plate.
The wheels must be assembled at the same height level.
Using a product with wheels assembled on a different
height level may cause damage of the cutting unit (e.g.
cutting device, spindle etc.) or an unsatisfactory result.
1. Release the start lever and disconnect the product from the
power supply before adjusting the height of the wheels.
2. Loose the knob and remove them together the wheel.
NOTE! To loosen the knobs on the right side (with silver bolts turn
anticlockwise, on the left side (with black bolts) turn clockwise.
3. Align the axle hole of the wheel with the required height
adjustment hole in the mounting plate and tighten the knob.
To Next Page
Loading...
Need help?
General
