AP4721 ML3000-SLV2 Fitting Notes 2
Software Compatibility
The ML3000 must be loaded with V1.31 or higher operating software for the SYS-LINK option
to function correctly. You can check the current version number of the console software using
a PC connected via RS232. Instructions for this and the latest version of software are
provided on the Allen & Heath Internet site
http://www.allen-heath.com/
Tools and Facilities Required
This work requires removal of the console base panel, fitting two internal circuit card
assemblies and plugging on IDC cable harnesses. To use SYS-LINK the option must be
installed into both consoles to be connected.
Provide a suitably large, well lit area such as in a service workshop. To avoid damage to the
cosmetics of the console ensure that the work surface is clean and clear of obstructions.
Allow enough time to carry out the installation and check the results. Allen & Heath do not
assume responsibility for damage due to incorrect installation of this option or it being carried
out by unqualified personnel.
Normal workshop tools are required. Depending on the age of the console these include
either size 1 and 2 Pozidriv (cross head) or size T10 and T15 Torx (star head) screwdrivers.
A 5mm nut spinner or spanner is also needed.
Fitting Instructions.
Note that these diagrams show the 24 channel ML3000. The same procedure applies to all
models.
Step 1: Before installation, remove console power and disconnect all cables and
attachments. Ensure adequate lighting and use the correct tools.
Step 2: Invert the console and remove the screws securing the base. Carefully lift the base
off, retaining all screws.
Step 3: Remove the three blanking plates (10 screws) located inside the rear connector
panels - Fig.1. The two circuit cards are to be fitted here.
To Next Page
Loading...
Need help?
General
