ALLEN & HEATH Qu-16 Reference Guide

Qu Mixer Reference Guide 57 AP9372 iss.9
10.9 Working with FX – Adding vocal reverb:
 Press the FX key to open the FX screen. Touch to select FX1.
Press the Fn key to open the Library page. Touch ‘Factory’.
Recall a Reverb into the FX1 slot if one is not already loaded.
Open the Back Panel view and check that FX1 is set for
Mix>Return with FX1 as its input.
 Start by turning up a vocal channel fader while the master
strip LR mix is selected to hear the signal in the main PA mix.
 Select the top layer to view the FX Return channel strips. Set
these faders to their ‘0’ position and check they are unmuted
to ensure the effect signals will be returned to the main mix.
 Press the FX1 Mix key. The master strip now presents the
FX1 Send master fader and controls. The channel faders
move to show the sends to FX1.
 Press the master strip Sel key to view the FX1 parameters on
the screen. Press the Fn key to access the library.
 Set the master strip fader to its ‘0’ position and check that it is
unmuted to ensure the channel sends will be sent to the FX.
 Move the vocal channel fader to adjust its send level to the
selected FX. This is similar to turning an Aux send knob on an
analogue mixer to feed an outboard effects unit.
 You should now hear the reverb added to the dry vocal
signal. Adjust the send fader for the amount of reverb you
want. You can also send other channels to the reverb by
turning up their send faders, for example backing vocals and
instruments.
 When done, remember to return the faders to the main mix by
turning off the FX1 Mix key or selecting the LR key.
 You can assign the FX sends or returns to a Mute Group if
you want to be able to turn off all the effects with a single key,
for example between songs.
 You can assign a SoftKey as a tap tempo key for a delay
effect. This lets you quickly tap in the beat for a vocal delay
without the need to open the FX screen.
Use the FX Library to recall different effects types and presets, or
to store your own parameter settings as User presets. Listen to
their effect on different signals and experiment with their levels
and settings so that you can use them as a creative tool while
mixing.
Sends on
faders

ALLEN & HEATH Qu-16 Specifications

General

Sample rate	48 kHz
Channels quantity	16 channels
Digital sound processing	- bit
Output impedance	75 Ω
Built-in display	Yes
AC input voltage	100 - 240 V
AC input frequency	50/60 Hz
Power consumption (typical)	82 W
XLR out	12
RJ-45 ports quantity	1
Headphone connectivity	6.3 mm
Number of microphone inputs	16
DJ mixer	-
Product color	Black
USB connector type	USB Type-A, USB Type-B

Weight and Dimensions

Depth	500 mm
Width	440 mm
Height	186 mm
Weight	10000 g
Package depth	680 mm
Package width	610 mm
Package height	350 mm
Package weight	13500 g