EasyManuals Logo
Home>ALLEN & HEATH>Music Mixer>ZED 14

ALLEN & HEATH ZED 14 User Manual

ALLEN & HEATH ZED 14
32 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #19 background imageLoading...
Page #19 background image
Allen & Heath 19 ZED-14 User Guide
USB & MASTER SECTION
1 2
3
4
1
Aux output jack sockets
Standard 1/4” jack sockets for Aux 1 to 4 outputs. Im-
pedance balanced, nominal level = 0dBu.
2
Mix L R Insert jack sockets
Standard 1/4” (6.25mm) Jack sockets for unbalanced in-
sert send and return signals. Wired Tip = send, Ring =
return, Sleeve = Chassis. Nominal level is 0dBu.
3
5
&
L
+16
-6
-9
-20
-30
-16
-12
-3
0
+3
+6
+9
R
PFL ACTIVE
MIN MAX
PHONES
AUX1
AUX2
2TRK RTN
USB RTN
STEREO
OO
+6
ALT
OUT
MONITOR
LR
OO
+6
AUX1
MASTER
OO
+6
AUX2
MASTER
5
20
10
5
0
10
POST
PRE
LR
L
R
POWER
48V
INSERT R
AUX1 OUT
PHONES
MAIN OUT
0
0
0
ALLEN HEATH
AUX2 OUT
AUX3 OUT
AUX4 OUT
INSERT L
MONO OUT
+16
-6
-9
-20
-30
-16
-12
-3
0
+3
+6
+9
Main L R output xlr sockets
Main left & right outputs. Impedance balanced signals,
pin1 = chassis, pin2 = hot (+), pin3 = cold (-). Nominal
level = 0dBu.
4
Mono output jack socket
A mono sum of the main left & right post-fade signals.
5
Headphones jack sockets
One 1/4” and one 3.5mm jack socket for stereo head-
phones. Wired Tip = left, Ring = right, Sleeve = Chassis.
It is recommended that headphones with an impedance
higher than 30ohms are used.
6
8
7
6
48v Phantom Power switch
Press this in to switch 48v Phantom Power to all the Mic
input xlr connectors, if any of the microphones attached
require power. Dynamic microphones won’t mind being
connected to a phantom powered input, but care is
needed to ensure that 48v is not switched on if an xlr is
used to input a signal from an electronic circuit (ie. An-
other mixer or keyboard).
When switching 48v on or off, or plugging in con-
nectors to channels with 48v present, it is impor-
tant (and normal practise) to mute the channels.
This will avoid loud clicks and bangs potentially
getting through to the amps & speakers with the
possible effect of damaging the speakers, or your
audience’s hearing!
7
Left Right meters
12 segment LED meters, peak type response, the “0”
position reflects 0dBu at the outputs. These display the
signals from the monitor selector switches below, or the
PFL (pre-fade listen) signals from any selected channels,
which overrides.
!

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the ALLEN & HEATH ZED 14 and is the answer not in the manual?

ALLEN & HEATH ZED 14 Specifications

General IconGeneral
BrandALLEN & HEATH
ModelZED 14
CategoryMusic Mixer
LanguageEnglish

Related product manuals