Allen-Bradley 20F User Manual

6 Rockwell Automation Publication 750-IN011F-EN-P - June 2017
PowerFlex 750-Series Power Jumpers
5 B
C
D
E
PE-A Installed
PE-B Not Installed
PE-A Installed
PE-B Installed
Solid Ground
Install jumper screws at ‘PE-A’ (MOV/Input Filter Cap) and
‘PE-B’ (CM Cap).
See page 4
for recommended torque.
Non-Solid Ground
Remove both jumper screws.
6 B
C
D
E
F
PE-A jumper wire
connected to ground.
PE-B jumper wire
insulated/disconnected
from ground.
PE-A jumper wire and
PE-B jumper wire
connected to ground.
Solid Ground
Connect the MOV/Input Filter Cap jumper wire (PE-A) and
the CM Cap jumper wire (PE-B) to ground.
See page 4
for recommended torque.
Non-Solid Ground
Insulate the MOV/Input Filter Cap jumper wire (PE-A) and
the CM Cap jumper wire (PE-B) from ground.
7 B
C
D
E
F
PE-A jumper wire
connected to ground.
PE-B jumper wire
insulated/disconnected
from ground.
PE-A jumper wire and
PE-B jumper wire
connected to ground.
Solid Ground
Connect the MOV/Input Filter Cap jumper wire (PE-A) and
the CM Cap jumper wire (PE-B) to ground.
See page 4
for recommended torque.
Non-Solid Ground
Insulate the MOV/Input Filter Cap jumper wire (PE-A) and
the CM Cap jumper wire (PE-B) from ground.
Jumper Locations and Settings (Continued)
Frame
Voltage
Code
Factory Default Jumper Settings
Power Source Type
Catalog Code ‘A’ Catalog Code ‘J’
PE-B
PE-A
DC+
PE-B
PE-A
E4
Insulated
Connected
Insulated
Connected
PE-B
PE-A
Insulated
Connected
Insulated
Connected

Allen-Bradley 20F Specifications

General

Brand	Allen-Bradley
Model	20F
Category	Controller
Language	English