Installation Instructions
Original Instructions
CompactLogix 5380 Controllers
Catalog Numbers
5069-L306ER, 5069-L306ERM, 5069-L310ER, 5069-L310ER-NSE, 5069-L310ERM, 5069-L320ER, 5069-L320ERM, 5069-L330ER,
5069-L330ERM, 5069-L340ER, 5069-L340ERM, 5069-L350ERM, 5069-L380ERM, 5069-L3100ERM
The CompactLogix™ 5380 controllers can operate in various applications, including the use of local Compact 5000™ I/O modules and remote I/O
modules and Integrated Motion over an EtherNet/IP network. The controllers offer the following:
• High-speed backplane packet transfer rate
• Embedded dual 1 Gb Ethernet ports
• Multiple programming languages that enable sequential, process, motion, and drive control
You use the Studio 5000 Logix Designer® application to configure CompactLogix 5380 controllers.
For more information on the components that are required to install a CompactLogix 5380 controller, see
page 5. For more information on how to
use the controller after you install it, see the publications that are listed in
Additional Resources on page 15.
Summary of Changes
The publication has been changed as follows:
• Add Waste Electrical and Electronic Equipment (WEEE) information on
page 3.
• Add information about how to install an end cap on
page 11.
Topic Page
About the Controller 5
Required System Components 5
Install the Controller onto the DIN Rail 8
Connect External Power Supplies to the Controller 8
Install Compact 5000 I/O Modules 11
Install the End Cap 11
Power the System 12
Set the Network Internet Protocol (IP) Addresses 12
Connect the Controller to an EtherNet/IP Network 12
Remove or Replace the Controller 13
Specifications 14
Additional Resources 15
To Next Page
Need help?
General
