Alpine CDE-182R User Manual

10-EN
Presetting Stations Automatically
1 Press BAND repeatedly until the desired radio band is
displayed.
2 Press and hold TUNEA.ME for at least 2 seconds.
The frequency on the display continues to change while the
automatic memory is in progress. The tuner will automatically
seek and store 6 strong stations in the selected band. They will
be stored into preset buttons 1 to 6 in order of signal strength.
When the automatic memory has been completed, the tuner
goes to the station stored in preset location No.1.
Note
• If no stations are stored, the tuner will return to the original station you
were listening to before the auto memory procedure began.
Tuning to Preset Stations
1 Press BAND repeatedly until the desired band is
displayed.
2 Press any one of the station preset buttons (1 through 6)
that has your desired radio station in memory.
The display shows the band, preset number and frequency of
the station selected.
Frequency Search Function
You can search for a radio station by its frequency.
1 Press ENTER in Radio mode to activate Frequency
search mode.
The “” indicator lights up.
2 Turn the Rotary encoder to select the desired frequency.
3 Press ENTER to receive the selected frequency.
Note
•Press r in the search mode to cancel. Or, the search mode will be
cancelled if no operation is performed for 10 seconds.
Turning AF (Alternative Frequencies) ON/OFF
The RDS (Radio Data System) is a radio information system using the
57 kHz subcarrier of regular FM broadcast. The RDS allows you to
receive a variety of information such as traffic information, station
names, and to automatically re-tune to a stronger transmitter that is
broadcasting the same programme.
1 Press and hold AUDIOSETUP for at least 2 seconds to
activate the SETUP selection mode.
2 Turn the Rotary encoder to select the “TUNER” setup
mode, and then press ENTER.
3 Turn the Rotary encoder to select the “AF”, and then press
ENTER.
4 Turn the Rotary encoder to select the AF (Alternative
Frequency) ON or OFF mode.
5 Press and hold AUDIOSETUP for at least 2 seconds to
return to normal mode.
Notes
• When the AF ON mode is selected, the unit automatically tunes to a
strong signal station in the AF list.
• Use the AF OFF mode when automatic re-tuning is not required.
•Press r to return to the previous mode.
• Pressing and holding r for at least 2 seconds will return to normal
mode.
• If no operation is performed for 60 seconds, the unit will return to
normal mode automatically.
The RDS digital data includes the following:
RDS
PI Programme Identification
PS Programme Service Name
AF List of Alternative Frequencies
TP Traffic Programme
TA Traffic Announcement
PTY Programme Type
EON Enhanced Other Networks
AUDIO/SETUP
/ENTER

BAND/TA
VIEW


Rotary encoder

Alpine CDE-182R Specifications

General

Brand	Alpine
Model	CDE-182R
Category	Car Receiver
Language	English