Alpine CDE-182R User Manual

27-EN
•No CD is inserted.
–Insert a CD.
• Although a disc is inserted, “NO DISC” is displayed and the unit does
not start to play or eject the disc.
– Remove the disc by following these steps:
Press the  button again for at least 2 seconds.
If the disc still does not eject, consult your Alpine dealer.
•Mechanism error.
1 Press the  button and eject the CD.
If not ejecting, consult your Alpine dealer.
2 When the error indication remains after ejecting, press the 
button again.
If the error indication still does not turn off after pressing the 
button for a few times, consult your Alpine dealer.
• A copy-protected WMA file was played back.
– You can only play back non-copy-protected files.
• A sampling rate/bit rate not supported by the unit is used.
– Use a sampling rate/bit rate that is supported by the unit.
• A USB device that is not supported by the unit is connected.
– Connect a USB device that is supported by the unit.
• A USB Memory Device is not connected.
– Make sure the USB Memory device is correctly connected and the
cable is not excessively bent.
• No MP3/WMA/AAC (file) is stored in the USB Memory.
– Connect the USB Memory device after storing songs (files).
• A copy-protected WMA file was played back.
– You can only play back non-copy-protected files.
• A sampling rate/bit rate not supported by the unit is used.
– Use a sampling rate/bit rate that is supported by the unit.
• Text information that is not recognisable by the unit has been input.
– Use a USB Memory device with input text information that is
supported by the unit.
• Communication error or others
– Change to other source.
– Turn the power off.
– Turn the ignition key off, and then set to ON again.
• Communication error
– Turn the ignition key off, and then set to ON again.
– Check the display by reconnecting between the USB Memory and
this unit.
• Power surge error
Excessive voltage/current is supplied to the USB Memory.
– Try another USB Memory, if available.
• The iPod/iPhone is not connected.
– Make sure the iPod/iPhone is correctly connected.
Make sure the cable is not bent excessively.
• There are no songs in the iPod/iPhone.
– Download songs to the iPod/iPhone and connect to this unit.
• Communication error
– Turn the ignition key off, and then set to ON again.
– Check the display by reconnecting between the iPod/iPhone and
this unit, using the iPod/iPhone cable.
Indication for CD Player
(CDE-182R/CDE-181 Series/CDE-180
Series only)
Indication for USB Memory
NO DEVICE
Indication for iPod Mode
(CDE-182R/CDE-181 Series only)
NO SUPPORT

Alpine CDE-182R Specifications

General

Brand	Alpine
Model	CDE-182R
Category	Car Receiver
Language	English