cleaning & Maintenance
COMBITHERM® CT PROFORMANCE™ SERIES • STEP-BY-STEP PROCEDURES • MN-35948 • 52.
CLEANING SCHEDULE
DAILY GASKET CLEANING
It is important to prolong the life of the oven gasket by
cleaning on a daily basis. Routine cleaning will help protect
the gasket from deterioration caused by acidic foods.
1. Allow the oven to cool, then wipe the gasket and crevices
with clean cloth soaked in warm detergent solution.
2. Wipe the gasket and crevices with a cloth and clean
rinse water.
Do not attempt to remove gasket or place in the dishwasher.
PROBE USAGE AND CLEANING
After each use of the CORE TEMP mode, wipe the probe tip
with a clean paper towel to remove food debris. Follow by
wiping the probe with a disposable alcohol pad. Return the
probe to the proper door bracket position.
Probe and Probe Prong Cleaning Procedures
1. Remove all food debris from probe between loads and at
the end of each production shift. Wipe the entire probe,
probe cable assembly, probe prongs, and probe holding
bracket with a clean cloth and warm detergent solution.
2. Remove detergent by wiping the probe, cable, probe
prongs, and bracket with a cloth and clean rinse water.
3. Wipe probe and probe bracket with disposable alcohol
pad or sanitizing solution recommended for food
contact surfaces.
4. Allow probe, probe prongs, and cable to air dry in the
probe holding bracket.
5. Wipe the probe with a disposable alcohol pad prior to
inserting into a new food product.
DAILY OVEN CLEANING
To be performed at the end of the production day or
between production shifts.
ROLL-IN CART/FOOD TROLLEY CLEANING (ON
EQUIPPED MODELS)
1. Remove food trolley to a cart wash area. Trolleys may
be cleaned using any mild cleaning detergent and warm
water.
2. Hand wipe all framing, slides, drip pan, and base.
Thoroughly clean debris from the casters. A spray hose
can be used for easier cart cleaning.
3. Remove detergent solution with warm water.
4. Wipe or spray with a sanitizing solution designed for use
on metal and vinyl food contact surfaces.
5. Allow trolley to air dry.
As an alternative, trolleys can be cleaned while inside the
oven. Allow the trolley to remain in the oven through
the heavy-duty PLUS cleaning cycle, followed by steps 2
through 5.
MONTHLY CLEANING
1. Spray Head
2. Water Intake Filters
3. Drain Pipe
AT NO TIME SHOULD THE INTERIOR
OR EXTERIOR BE STEAM CLEANED,
HOSED DOWN, OR FLOODED WITH
WATER OR LIQUID SOLUTION OF
ANY KIND. DO NOT USE WATER JET
TO CLEAN.
SEVERE DAMAGE OR
ELECTRICAL HAZARD
COULD RESULT.
WARRANTY BECOMES VOID IF
APPLIANCE IS FLOODED
UNTREATED WATER
TREATED WATER
WATER DRAIN
To Next Page
Loading...
Need help?
General
