TROUBLESHOOTING
Vector™ H Seri es ▪ Serv ic e M anua l ▪ MN- 4654 4 ▪ Re v 01 ▪ 1 1/19
58
Door Handle Light does not Illuminate
Before you start Remove the service panel.
WARNING: Electric shock and arc flash hazard.
Use caution when measuring line voltage.
Wear Personal Protective Equipment (PPE).
NOTICE
Do not operate the oven in a cooking mode for an extended
period of time with the top panel removed. Damage to the
electronics may occur without adequate cooling airflow.
An auxiliary fan must be used if the oven will be operated in a
cooking mode for an extended period of time with the top
panel removed.
Is the oven running a cook mode?
No
Activation of the handle light
happens when the oven starts a
cook cycle.
Yes
Is the handle light activated in the settings screen?
No
Check the operational settings and
turn on the door handle light.
Yes
Is there 12VDC out of the P4 terminal on the control
board?
No
Check the connector and
connection. Replace the control
board if the connector and
connections are good.
Yes
Is there 12VDC at the light connection in the handle?
No
Inspect the door handle light wiring
from the control board to the light.
Repair or fix any damage, open, or
lose connections in the wiring.
Yes
Replace the handle.
To Next Page
Loading...
Need help?
General
