INSTALLATION
Vecto r H® S eries ▪ Opera tor’s Manual ▪ M N-462 9 5 ▪ Rev 7 ▪ 6/22
32
How to Install the Oven
(50/60 Hz Models Without Cords or Plugs)
Before you begin Make sure you have:
▪ Appropriate cord and plug, minimum oil resistant HO7RN-F. See local codes and
regulations.
▪ Screwdriver (Phillips #2)
▪ Nut driver (1/4-inch)
▪ An appropriate lifting device, and enough personnel, to safely move and position
the weight of the oven.
□ VMC-H2/H2H: 213 lb (97 kg)
□ VMC-H3/H3H: 278 lb (126 kg)
□ VMC-H4/H4H: 348 lb (158 kg)
□ VMC-H2HW: 243 lb (110 kg)
□ VMC-H3HW: 312 lb (142 kg)
Requirements ▪ The oven must be installed on a level surface.
▪ The oven must not be installed in any area where it may be affected by steam,
grease, dripping water, high temperature, or any other severely adverse
conditions.
▪ If required by local codes, use Type F RCD.
▪ The oven is not intended for built-in installation.
Continued on next page
WARNING: Electric shock hazard.
Make sure the supply cord and plug have an earth connection
(ground).
To Next Page
Loading...
Need help?
General
