Amigo RD Operational Manual

Models with TouchTron controls have an additional electromagnetic brake
release button located on the handle (Figure 6). To electronically release
the electromagnetic brake, push the brake release button twice. The low-
speed segment of the speed gauge will blink to indicate you are now in
the freewheeling mode. To terminate the freewheeling mode when selected
electronically, activate any control button (except horn button)
on the TouchTron handle.
Brake Releases for Manual Pushing
Electromagnetic brake release (located on handle) – Figure 6
Manual brake lever (located on rear cover) – Figure 5
Sleep Mode
A battery indicator and diagnostic system are incorporated into the touchpad of all Amigo rear drive models with a
TouchTron handle. The battery status gauge will be lit whenever the key is in the ON position. However, if the Amigo is
inactive for more than 25 minutes, the Amigo automatically switches to “sleep mode.” This feature substantially reduces
power to conserve battery capacity. To reactivate your Amigo, switch it OFF and then ON again to regain full function.
It is strongly recommended that you turn the key to the OFF position each time
you are through using the Amigo to ensure the power is completely turned off.
Power Seat Lift Operation • Optional
To operate the power seat lift on Amigo models with a TouchTron handle,
press the seat/directional arrow buttons to raise or lower the seat (Figure 7).
To lift the seat to desired height, press the seat button with the arrow pointing
up. To lower the seat, press the seat button with the arrow pointing down.
The power seat lift can be activated only when you are not moving.
Always drive with the power seat lift in its lowest position.
TO AVOID DAMAGING THE MOTOR OF THE POWER SEAT LIFT,
RELEASE THE SEAT BUTTON AFTER THE SEAT HAS REACHED ITS
HIGHEST OR LOWEST POINT.
High Intensity Light Package Operation • Optional
The optional lighting package available with the TouchTron handle includes a front headlight, rear tail lights
and turn signals. The power must be ON to operate the headlight or tail lights. The headlight and tail lights can
be activated by pressing the headlight button (Figure 6). Press this button again to turn the lights off.
The turn signals can be activated by pressing the left or right turn indicator buttons (Figure 7). Indicate a
“hazard” condition by pressing both turn indicator buttons. The power must be ON to operate the lights.
RIDING YOUR AMIGO
Be sure you are on a level surface. Insert the key in the switch, but leave the Amigo turned OFF.
Once seated, for safe transfer or driving, push seat lock lever forward (located under seat on the right side)
to easily position the seat as needed. Engage lever back to the locked position. Turn the speed adjustment knob
counterclockwise and turn the key to the ON position. Pull the right accelerator lever to start off in a forward motion.
To stop, simply let go.
Figure 7
Figure 6
Headlight/
Tail lights
Electronic
brake
switch
Turn indicator Turn indicator
www.myamigo.com 7
Down
Up

Amigo RD Specifications

General

Brand	Amigo
Model	RD
Category	Scooter
Language	English