Product Information
3
PLB-AMP8 8-Channel Audio Power Amplifier
! The first press selects all channels: Channels 1 through 8.
! The next four presses select stereo channel pairs: Channels 1-2, 3-4, 5-6, or 7-8.
! The next eight presses select individual channels: Channel 1, 2, 3, 4, 5, 6, 7, or 8.
! If you changed any levels, the next press selects Save All modes.
! If you did not change any levels, the next press selects Idle mode.
Procedure for Setting Channel Volume Levels:
1. Turn on the amplifier as described above. A dot appears in the LED display.
2. Press the right-arrow button the required number of times to illuminate the LED above the first
channels or channel pair that you want to set.
3. The volume level is adjusted up or down each time you press the up- or down- arrow button.
Press the up- or down-arrow button the required number of times to set the volume level to the
desired level.
4. If there are additional channels you want to set, repeat steps 2 and 3 until you have set the
volume levels for all channels.
5. Press the up-arrow button (Yes) to save all of the channel settings (SC). Any changes you made
are saved. Channel levels that you did not change remain at their previous settings.
6. Press the right-arrow button the required number of times to display SA (Save) in the LED
display.
7. Press the down-arrow button (No) to cancel the save.
FIG. 3 Individual LEDs above each channel
SA will not appear unless you have made at least one level change.
If you wait too long while SA is displayed, the changes will not be saved. When power
is cycled, the amplifier will return to the last level you saved.
To Next Page
Need help?
General
