65
use and maintenance RS 50
ADJUSTING THE VERTICAL
HEADLIGHT BEAM
To rapidly check the correct direction of the
beam, place the vehicle on flat ground, 10
m away from a wall.
Turn on the low beam, sit on the vehicle
and make sure that the beam projected on
the wall is slightly under the horizontal line
of the headlight (about 9/10th of the total
height).
To adjust the headlight beam:
◆
Working on the rear left side of the front
part of the fairing, adjust the appropriate
screw (1) by means of a short cross-tip
screwdriver.
By SCREWING IT (clockwise), you set
the beam upwards.
By UNSCREWING IT (anticlockwise),
you set the beam downwards.
BULBS
Carefully read p. 39 (MAINTENANCE).
CAUTION
Before changing a bulb, turn the igni-
tion switch to position “
”.
Change the bulb wearing clean gloves
or using a clean and dry cloth.
Do not leave fingerprints on the bulb,
since these may cause its overheating
and consequent breakage.
If you touch the bulb with bare hands,
remove any fingerprint with alcohol, in
order to prevent it from blowing.
DO NOT FORCE THE ELECTRIC
CABLES.
To Next Page
Loading...
Need help?
General
