Aritech ATS3000 User Manual

INHIBITING A ZONE
This function is used to inhibit zones and exclude
them from the security system. You do this, for ex-
ample, when an zone is faulty or broken. By inhib-
iting it, you stop it causing an alarm until it is
fixed.
There may also be occasions when you want to in-
hibit a normal zone. For example, if you want to
leave a window open when the system is armed. By
inhibiting the zone associated with the window,
when you arm the system you will not set the alarm.
12 ATS User’s Manual
Start with the Code line on the bottom line
of the display.
Press the MENU* button
Enter your PIN Code
Press 10 and ENTER.
What happens next depends on whether or not there
are inhibited zones:
All zones are normal- You can inhibit normal zones if
you know their zone number.
Enter the zone number and press ENTER to inhibit
the zone, or press CLEAR to exit programming.
Active zones - There are one or more zones active.
These zones are listed either:
- one by one, or
- as a list of numbers
When the zones are listed one by one, to scroll use
the NEXT button
Depending on the state of the zones you can:
• Inhibit the active zone
Enter the Zone N° and then press ENTER.
When finished, press ENTER and CLEAR to exit
programming.
• Inhibit the normal zone
Enter the Zone N° and then press ENTER.
When finished, press ENTER and CLEAR to exit
programming.
• Exit - lets you exit programming.
Press CLEAR.
Press ENTER
(See page 6 for more information on accessing menu options)
○○○○○○○○○○○○○○○○○
○○○○○○○○○○○○○○○○○○○○○○
○○○○○○○
○○○○○○○○○○○○○○○○○○
○○○○○○○
○
○○○○○○
○○○○○
○

Aritech ATS3000 Specifications

General

Brand	Aritech
Model	ATS3000
Category	Control Panel
Language	English