5-26
Chapter 5: Software support
5.4 RAID 0/RAID 1 configurations
The motherboard includes the Promise
®
PDC20376 controller chipset, two
Serial ATA interfaces, and a Parallel ATA133 interface to support
Redundant Array of Independent Disks (RAID) configuration. This feature
supports Ultra ATA/133 drives, and is backward compatible with Ultra ATA/
100/66/33 drives. Use the MBFastTrak376™ BIOS and the FastBuild™
utility to configure a disk array.
RAID 0 (called data striping) optimizes two identical hard disk drives to
read and write data in parallel, interleaved stacks. Two hard disks perform
the same work as a single drive but at a sustained data transfer rate,
double that of a single disk alone, thus improving data access and
storage.
RAID 1 (called data mirroring) copies and maintains an identical image of
data from one drive to a second drive. If one drive fails, the disk array
management software directs all applications to the surviving drive as it
contains a complete copy of the data in the other drive. This RAID
configuration provides data protection and increases fault tolerance to the
entire system.
5.4.1 Install the hard disks
The PDC20376 chipset supports Ultra ATA/133/100/66 hard disk drives.
For optimal performance, install identical drives of the same model and
capacity when creating a disk array.
• If you are creating a RAID 0 (striping) array for perfomance, use two
new drives.
• If you are creating a RAID 1 (mirroring) array for protection, you can use
two new drives or use an existing drive and a new drive (the new drive
must be of the same size or larger than the existing drive).
The chipset supports RAID 0 (striping) or RAID 1 (mirroring) for master
drives only.
The Promise PDC20376 chipset only supports one Master HDD on
the PRI_RAID1 connector. HDDs set to Slave mode and ATAPI
devices such as CD-ROMs, DVD-ROMs, etc. are not supported.
To Next Page
Loading...
Need help?
General
