ASUS P8B-C series 5-35
5.4 LSI Corporation MPT Setup Utility
(P8B-C/SAS/2L, P8B-C/SAS/4L only)
The LSI Corporation MPT Setup Utility is an integrated RAID solution that allows
you to create the following RAID sets from SAS hard disk drives supported by the
LSI 2008 controller: RAID 0, RAID 1, RAID 1E, and RAID 10.
• You may use disks of different sizes in one volume; however, the size of the
smallest disk determines the “logical” size of each member disk.
• DO NOT combine Serial ATA and SAS disk drives in one volume.
• The RAID setup screens shown in this section are for reference only and
may not exactly match the items on your screen due to the controller
version difference.
• The adapter name shown on the setup screens differs according to the
installed SAS RAID card.
• Before requesting support from the ASUS Technical Support team, you
have to take note of the MPTFW and MPTBIOS version for the SAS
controller. After entering the SAS conguration utility, you can see below
screen and identify the MPTFW and MPTBIOS version:
MPTFW version: 8.00.00.00-IR
MPTBIOS version: v7.07.00.00 (2010.04.30)
Esc = Exit Menu F1/Shift+1 = Help
Alt+N = Global Properties -/+ = Alter Boot Order Ins/Del = Alter Boot List
LSI Corp Cong Utility v7.07.00.00 (2010.04.30)
Adapter List Global Properties
Adapter PCI PCI PCI PCI FW Revision Status Boot
BUS Dev Fnc Slot Order
SAS 2008 01 00 00 00 8.00.00.00-IR Enabled 0
To Next Page
Loading...
Need help?
General
