2.6.7 Onboard Devices Configuration
HD Audio Controller [Enabled]
[Enabled] Enables the HD Audio Device.
[Disabled] Disables the HD Audio Device.
The following two items appear only when you set the HD Audio Controller item to
[Enabled].
Front Panel Type [HD Audio]
Allows you to set the front panel audio connector (AAFP) mode to legacy AC’97 or
high-denition audio depending on the audio standard that the front panel audio
module supports.
[HD] Sets the front panel audio connector (AAFP) mode to high denition
audio.
[AC97] Sets the front panel audio connector (AAFP) mode to legacy AC’97
SPDIF Out Type [SPDIF]
[SPDIF] Sets to an SPDIF audio output.
[HDMI] Sets to an HDMI audio output.
Audio Shielding LED [Breathing Mode]
This item allows you to set the audio shielding LED mode. Conguration options: [Disabled]
[Still Mode] [Breathing Mode]
M.2 and SATA Express Mode Configuration [SATA EXpress]
[M.2] SATA mode will be switched to M.2. SATA Express can only support PCIE
devices.
[SATA EXpress] SATA mode will be switched to SATA Express. M.2 can only support PCIE
devices.
Realtek LAN Controller [On]
[On] Enables the Realtek LAN controller.
[Off] Disables the controller.
Realtek PXE Option ROM [Off]
This item appears only when you set the previous item to [On] and allows you to enable or
disable the PXE OptionRom of the Realtek LAN controller. Conguration options: [On] [Off]
Serial Port Configuration
The sub-items in this menu allow you to set the serial port conguration.
Serial Port [On]
Allows you to enable or disable the serial port (COM).Conguration options: [On] [Off]
Change Settings [IO=3F8h; IRQ=4]
This item appears only when you set the Serial Port to [On] and allows you to select
the Serial Port base address. Conguration options: [IO=3F8h; IRQ=4] [IO=2F8h;
IRQ=3] [IO=3E8h; IRQ=4] [IO=2E8h; IRQ=3]
2-34 Chapter 2: Getting started