Atag A203C User Manual

ATAG A-Serie
23
The hot water supply has been preset in the
factory to Comfort. This means that hot water is
available instantly when you open the hot water
tap. If desired, you can choose the Eco mode.
This means that when tapping, it will take a little
longer before hot water will ow from the hot water
tap. This depends on the pipe length between the
boiler and water points and the current heating
temperature.
Changing the setting:
Press the OK key for 3 seconds.
The display is showing ‘P6 (alternated with) 81’;
Press the Scroll key 1x;
The display is showing ‘P6 (alternated with) 84’;
Press the OK key;
The display is showing ‘b0’;
Press the Scroll key 1x;
The display is showing ‘b1’;
Press the OK key;
The display is showing ‘on’ (= Comfort);
Adjust the value by means of the + or - key to
‘off’ (= Eco);
Briey press the OK key to conrm the new
setting.
The display is showing the chosen parameter
again
Press the ESC key until the default display is
shown again.
If during 8 minutes no key has been used,
the default display is displayed on the screen
automatically.
OK
ESC
scroll
7 Comfort/Eco setting of hot water

Atag A203C Specifications

General

Type	-
Fuel type	Natural gas
Boiler system	Combi boiler system
Product color	White
Heater location	Indoor
Placement supported	Vertical
Boiler type (NL label)	HR
HR inspection label class	107
Maximum power	20000 W
Minimum power	4400 W
Water flow (60 °C)	6 l/min
Domestic Hot Water (DHW) flow	10.7 l/min

Weight and Dimensions

Depth	395 mm
Width	500 mm
Height	650 mm
Weight	37000 g