Name: Atag A203C
Brand: Atag
Rating: 5 (1 reviews)

To Next Page

To Previous Page

ATAG A-Serie

The pump is preset in the factory to automatic. This

means that the pump is switched on when there is

a request for heating or hot water. If necessary, the

pump can also operate continuously. This requires

the following actions:

Press the OK key for 3 seconds.

The display is showing ‘P6 (alternated with) 81’;

Press the Scroll key 1x;

The display is showing ‘P6 (alternated with) 84’;

Press the OK key;

The display is showing ‘b0’;

Press the OK key;

The display is showing ‘off’ (= automatic);

Adjust the value by means of the + or - key to

‘on’ (= continuously);

Briey press the OK key to conrm the new

setting.

The display is showing the chosen parameter

again

Press the ESC key until the default display is

shown again.

An arrow appears on the display in the bottom

left-hand corner, indicating that the pump is now

continuously switched on.

If during 8 minutes no key has been pressed,

the default display is displayed on the screen

automatically.

In case of frost you are

advised to have the

circulation pump run

continuously to reduce the

chance of frozen pipes.

8 Pump continuous

ESC

scroll

Other manuals for Atag A203C

Questions and Answers:

Need help?

Do you have a question about the Atag A203C and is the answer not in the manual?

General